• high performed digital print
  • 650 motives
  • save purchase
  • order processing
  • Consulting: info@garagecover.de
  • high performed digital print
  • 650 motives
  • save purchase
  • order processing
  • Consulting: info@garagecover.de

Installation of your garagecover made of rigid PVC foam panels


Please read the installation instructions from beginning to end before you start, as there are dependencies opposite to the order.

The basic cleaning of the garage door should already have taken place.

The total weight of the two plates for a standard swing gate is about 8kg at 3mm thickness and at 5mm thickness (standard) about 12kg. Please note that you should set the garage door springs to a higher voltage, so that the additional weight is compensated. If this is not enough, you would need to use stronger garage door springs and / or a stronger garage motor. These are available in stationary stores, as well as in the Internet trade. We recommend having the installation carried out by qualified specialist personnel.

For sliding gates and doors this aspect is not important.

We come to you and install your garagecover, within a radius of about 50km from Mönchengladbach. Talk to us.


Evenly spray the future adhesive surface of the Velcro strip with isopropanol. Make sure that the cleaning agent does not come into contact with the printed side.

Cleaning the adhesive surfaces on the plate with a strong alcoholic detergent, e.g. Isopropanol, as the adhesive surface must be absolutely free of dirt and grease. Isopropanol can also be found in our shop under "Accessories".

If you still want to attach an LED light strip, mark the adhesive surface at the upper edge of the plate with 4 cm distance. This is the space that the clamp mount of the LED light bar needs.

Now you cut the Velcro, and glue the tape without pulling, and repeat the process on the second plate.

The Velcro should be on both sides (plate and garage door) for about 60 min. be given the opportunity to enter into a permanent liability.

Reinigen der Klebeflächen auf dem Garagentor mit Isopropanol.


Here the 4 cm distance with respect to the LED light bar reappear. So mark here too, measured from the top edge.

Sticking the Velcro tape on the slats top and bottom (plus 4 cm for LED light bar)

Stick the Velcro tape on the trapezoidal sheet.

Shown here without the 4 cm distance.


Now comes the first board.

Start at the top and ...


... lightly press (stick).


The same with the second plate. Rarely do you get the plates, right the first time, just placed on the garage door. Therefore, you press the plates until the very end.

And your garagecover is done!



PS .: If you like this theme, this is a lighthouse on the Baltic Sea. You can find it in the shop under the heading "Heimleuchten".