• high performed digital print
  • 650 motives
  • save purchase
  • order processing
  • Consulting: info@garagecover.de
  • high performed digital print
  • 650 motives
  • save purchase
  • order processing
  • Consulting: info@garagecover.de

Installation of your garagecover made of aluminum composite panels


Please read the installation instructions from beginning to end before you start, as there are dependencies opposite to the order.

The basic cleaning of the garage door should already have taken place.

The total weight of the two plates for a standard swing gate is about 22kg. For an electrically operated overhead door we recommend a motor with a power of 1000N, which compensates for the additional weight. These motors are available from stationary dealers, as well as in the Internet trade. We also recommend having the installation carried out by qualified personnel. For sliding gates and doors this aspect is not important.

The boards have sharp edges, best use work gloves.

We come to you and install your garagecover, within a radius of about 50km from Mönchengladbach. Talk to us.

Remove the protective foil and evenly spray the future adhesive surface of the Velcro tape with isopropanol. Make sure that the cleaning agent does not come into contact with the printed side.

Cleaning the adhesive surfaces on the plate with a strong alcoholic detergent, e.g. Isopropanol, as the adhesive surface must be absolutely free of dirt and grease. Isopropanol can also be found in our shop under "Accessories".

If you still want to attach an LED light strip, mark the adhesive surface at the upper edge of the plate with 4 cm distance. This is the space that the clamp mount of the LED light bar needs.

Now you cut the Velcro, and glue the tape without pulling, and repeat the process on the second plate.

The Velcro should be on both sides (plate and garage door) for about 60 min. be given the opportunity to enter into a permanent liability.

Cleaning the adhesive surfaces on the garage door.


Here, the 4 cm distance from just reappear. So mark here too, measured from the top edge.

Sticking the Velcro tape on the slats top and bottom (plus 4 cm for LED light bar)

Stick the Velcro tape on the trapezoidal sheet.

Shown here without the 4 cm distance.


Now comes the first plate.

Start at the top and ...


... lightly press (stick).


The same with the second plate.Rarely do you get the plates, right the first time, just placed on the garage door.Therefore, you press the plates until the very end.

And your garagecover is done!




PS .: If you like this theme, this is a lighthouse on the Baltic Sea.You can find it in the shop under the heading "Heimleuchten".